How to install the Transit+ controller and the fail safe/fail secure locks

Controllers are designed to be wall mounted through 4 screws but can also be DIN rail mounted. 

A cover is supplied. 

Wiring Diagram - PSU & Readers:

The controllers communicate through BLE with the mobile phone. 

NOTE: The USB plug is only used by the factory. 

NOTE: the green led is ON while the relay is activated. The red led flashes once every 3 secs when the reader is working fine and is flashing 3 times/sec if the reader is not connected or not answering to the controller. 

Wiring Diagram - Lock

When a fail-safe lock is used, a second security must be used to prevent an issue between the REX push button and the controller.

Basically, a break glass is connected in serial with the lock psu or the push button manages two dry contacts : 1 NO contact for the controller REX input + 1 NC contact in serial with the lock or maglock psu. (see wiring diagram above).

When a fail secure lock is used, the REX push button is NO as shown below. 

Fail Secure Lock

Fail Safe Lock/Maglocks

Test the Controller

Matt is the author of this solution article.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.