How do I install the Transit+ controller and the fail safe/fail secure locks?

Controllers are designed to be wall mounted through 4 screws but can also be DIN rail mounted. 

A cover is supplied. 

Wiring Diagram - PSU & Readers:

The controllers communicate through BLE with the mobile phone. 

NOTE: The USB plug is only used by the factory. 

NOTE: the green led is ON while the relay is activated. The red led flashes once every 3 secs when the reader is working fine and is flashing 3 times/sec if the reader is not connected or not answering to the controller. 

Wiring Diagram - Lock

When a fail-safe lock is used, a second security must be used to prevent an issue between the REX push button and the controller.

Basically, a break glass is connected in serial with the lock psu or the push button manages two dry contacts : 1 NO contact for the controller REX input + 1 NC contact in serial with the lock or maglock psu. (see wiring diagram above).

When a fail secure lock is used, the REX push button is NO as shown below. 

Fail Secure Lock

Fail Safe Lock/Maglocks

Test the Controller

For more information on the Transit+ Controller, please click here 

M
Matt is the author of this solution article.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.