How do I program a K-Steel 1156/10 or a Sinthesi 1105/2 keypad?

This article will show you how to program or change the door open code on an Urmet K-Steel 1156/10 keypad and an Urmet Sinthesi 1105/2 keypad.

Program keypad

  1. Press the button on the rear of the keypad three times within a time period of six seconds
  2. Enter a password (must be six digits) and press the ‘Key’ button
  3. Enter the door release time, for example for five seconds press 5 and then press the ‘Key’ button
  4. Enter the first door open code (between three and eight digits) and press the ‘Key’ button
  5. Up to eight different door open codes can be entered. After you have finished entering door open codes press and hold the ‘X’ button until a long bleep is heard. This will exit from the programming mode

 To change the door open code proceed as follows 

  1. Press the ‘Key’ button followed by the ‘X’ button followed by the ‘Key’ button; now enter the six-digit password
  2. Press the ‘Key’ button twice. • Press 5 (for 5 seconds door release time) and press the ‘Key’ button
  3. Enter the new door open code (between three and eight digits) and press the ‘Key’ button
  4. Up to eight different door open codes and be entered. After you have finished entering door open codes press and hold the ‘X’ button until a long bleep is heard. This will exit from the programming mode

Click here for more information on the K-Steel 1156/10 keypad


M
Mark is the author of this solution article.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.